How would you access this end-link slot?

M'Bob
Posts
7,091
Likes
22,989
These vintage no. 6 end-link slots are about 1mm wide:

IMG_3441.jpeg


As you can see, the Bergeon tool end is too wide to access it. The only way I’ve been able to access the slot for spring bar removal is with a .80 screwdriver tip. The problem is, the diameter of the tip is relatively small, and it flexes almost to the point of snapping at times. Thus, I’d be appreciative of any ideas on how to access this slot effectively. Thanks.
 
Dan S
Posts
23,127
Likes
51,629
Yes, a small screwdriver. If yours is flimsy, you could grind down a sturdier screwdriver to the correct width and shape. I have similar slots in several endlinks.
 
Archer
Posts
29,111
Likes
75,238
Uh, cut down the Bergeon tip so it fits...
 
M'Bob
Posts
7,091
Likes
22,989
Dan S Dan S
Yes, a small screwdriver. If yours is flimsy, you could grind down a sturdier screwdriver to the correct width and shape. I have similar slots in several endlinks.
Archer Archer
Uh, cut down the Bergeon tip so it fits...

Thanks. I was wondering if there was something dedicated that was the correct size.
 
Sign up or log in to reply...